![]() |
| Figure 1: The specified pass/fail mask for the transmitter power spectral density test |
You need to test, we're here to help.
You need to test, we're here to help.
17 October 2017
Automotive Ethernet Compliance: Tests in Detail (Part IV)
12 October 2017
Automotive Ethernet Compliance: Tests in Detail (Part III)
![]() |
| Figure 1: This depicts the setup for the Automotive Ethernet transmitter distortion test |
19 September 2017
Automotive Ethernet Compliance: Tests in Detail (Part II)
![]() |
| Figure 1: Testing transmitter timing master jitter entails creating a track of TIE measurements |
13 September 2017
Automotive Ethernet Compliance: Tests in Detail (Part I)
![]() |
| Figure 1: Maximum transmitter output droop should not exceed the specified maximum of 45% |
08 September 2017
Automotive Ethernet Compliance: Test Setup Overview
![]() |
| Figure 1: Typical test setup for Automotive Ethernet PMA compliance test |
30 August 2017
Automotive Ethernet Compliance: The Five Test Modes
![]() |
| Figure 1:Automotive Ethernet electrical compliance test is defined at the connector of the transmitter |
24 August 2017
Introduction to Automotive Ethernet Compliance Testing
As with most any networking scheme, Automotive Ethernet is subject to standardization to ensure that the various components of a given system reliably pass signals among themselves. Where there is a standard for a protocol, there must also be testing for compliance with that standard. This will be the first in a series of posts detailing compliance test of the Physical Media Attachment (PMA) aspect of the Automotive Ethernet standard.
Subscribe to:
Posts (Atom)





