10x Passive Probes and Cable Reflections

Figure 1: With unequal impedances at either end of the coax,
are cable reflections a concern in 10x passive probes?

We've been discussing the ubiquitous 10x passive probe here on Test Happens, beginning with an overview of the probe-oscilloscope system. We turned to the 10x passive probe itself and the issues posed by its constitutive circuitry. Then we covered what about that circuitry makes it usable at all, namely, its built-in equalization circuit.

How Tip Inductance Impacts a Probing System's Bandwidth

Figure 1: Shown are FFT plots of a 10-MHz, fast-edge square
wave reaching the oscilloscope via direct coax connection
(orange-yellow plot) and 10x passive probe fitted with a coax
tip adapter (straw-colored plot)

If you're using 10x passive probes with your oscilloscope, it's important to understand the bandwidth of your probing system and how it's affected by various methods of probing the signal of interest. There's a relatively easy way to determine this parameter by probing a fast-edge, 10-MHz signal from a square-wave generator. Doing so can also instruct us in the effects of tip inductance on the probe's bandwidth.

How Equalization Works in 10x Passive Probes

Figure 1: The adjustable equalization circuit on the oscilloscope
end of the coaxial cable compensates for the 10x passive
probe's inherent low-pass filter characteristics

We've been discussing 10x passive probes and their inner workings; our last post covered all the ways in which a 10x passive probe is apt to be a liability. They'd be basically unusable for any measurements at all but for one attribute: their equalization circuit (Figure 1). Without it, the 10x passive probe makes a pretty good low-pass filter, but the equalization circuit counters that with a high-pass filter to balance things out.

Secrets of the 10x Passive Probe

Figure 1: The 10x passive probe
becomes a better measurement
tool when we understand its
limitations

We began this series of posts on oscilloscope probes by putting them in perspective: Probes have a number of different jobs to do, including serving effectively as both a mechanical and electrical interface. Despite having electrical attributes of their own, we want them to grab our signal of interest, but we don't want them to affect that signal in any way.

Putting Probes in Perspective

Figure 1: Probe, cable, and oscilloscope form a system
that makes or breaks the accuracy of signal acquisitions

Few aspects of using an oscilloscope are as important as the probe: after all, the probe forms both the mechanical and electrical interfaces between the device under test (DUT) and the oscilloscope itself. To feed a signal into an oscilloscope, we're limited to a coaxial connection. Thus, we need a geometry transformer that picks up the signal of interest from the DUT and transfers it to the oscilloscope's coaxial connection.

Decision Feedback Equalization

Figure 1: DFE filter output is based on
a linear combination of previous bit
decisions

In debugging high-speed serial links, one must be cognizant of various forms of equalization that might be used in the link to compensate for signal degradation in the channel. Inter-symbol interference (ISI), attenuation, impedance mismatches, and insertion losses can all contribute to this loss of signal quality. To combat these effects, designers implement techniques such as continuous time linear equalization and feed-forward equalization.

The Causes of Ground Bounce and How To Avoid It

Figure 1: This cross section of a 100-MHz microstrip
transmission line shows us how a return path should look

We've been discussing the topic of ground bounce on digital I/O lines as well as an effective way to diagnose and analyze it. We've also run through a detailed example of how to measure it using a quiet-low I/O driver as a sense line. Now, let's take a step back and examine the root causes of ground bounce, and also discuss some best design practices for avoiding it altogether.